-
Numark DJ/IO problems
Hi,
I'm running a Macbook Pro with Traktor Pro 2, VCI100SE, and Numark DJ/IO soundcard.
Recently, I've had a problem with the DJ/IO. Everything on the screen on Traktor suggests it should be working, and the light is on on the unit. However, there's no sound produced from the master, and i can't even cue through the headphones.
Anyone else had similar problems?
thanks
-
Have you checked the Numark DJ/IO is selected in your Audio Setup
And in Output Routing check that Internal is selected and the Output Monitor & Output Master have your soundcard selected?
-
Yep. It is set up as follows:
Audio Device: Numark USB Audio Device
Mixing: Internal
Output monitor L - 3: Out 3
R - 4: Out 4
Output master L - 2: Out 2
R - 1: Out 1
This is the config. I've always used...
-
That sounds right.
Have you tried using the soundcard with anything else?
See if it's a traktor problem or a soundcard problem?
-
check the m-audio audio codec settings panel and check your latency settings. I had my latency settings reset and nothing was coming out of my DJiO 10 minutes before a show. I checked the latency and boom. It was right there.
also while you may feel dumb if you did this (i have) check your main output in traktor and your speaker's volume. I have left these at 0 and was like WTF!!!!!
if that fails try fully uninstalling drivers and reinstall?
Hope you can get your DJiO to work!