Fixing/Replacing Touch Sensor Level

Does anyone know of a way to fix or replace a touch sensor level adjustment found on the back of the VCI-100 my problem is this when I bought my VCI-100 one of the touch sensor levels broke the first time I tried adjusting the stupid thing unfortunately for me that's the one damn part on the VCI-100 that wasn't built like a tank.

As a result though I haven't gotten much use out of the device because some how it's attached with the cross fade curve on the back as well apparently in some way or another. If anyone knows anything helpful let me know would appreciate it. I figured since this is the mod section maybe someones knowledgeable enough to have a easy enough solution perhaps.

Those little things in the back are just variable resistors, you could find out the resistance value then buy another variable resistor just like it and solder it in yourself.

Hi,

I've got the same problem as above - one of my "touch sensol level" triggers is completely out of order and the last settings seems to be set at MAXimum sensitivity level - means that if I'll be playing in the club, it could get the vibration from the table and mess up with the phase.

apart from replacement of the resistor - is there any way how to adjust the level by some piece of software? is there anything like that available?

any ideas?

Thanks very much!

Quote:

---

Originally Posted by Chris Wright

Does anyone know of a way to fix or replace a touch sensor level adjustment found on the back of the VCI-100 my problem is this when I bought my VCI-100 one of the touch sensor levels broke the first time I tried adjusting the stupid thing unfortunately for me that's the one damn part on the VCI-100 that wasn't built like a tank.

As a result though I haven't gotten much use out of the device because some how it's attached with the cross fade curve on the back as well apparently in some way or another. If anyone knows anything helpful let me know would appreciate it. I figured since this is the mod section maybe someones knowledgeable enough to have a easy enough solution perhaps.

---

did you fix it?

My sensor level control also broke and something weird happened to my Cf curve control. THe jog wheel lights permanently stay red and the sensor led is also permanently on when I have the curve set to fast cutoff(for scratching).

Quote:

---

Originally Posted by BentoSan

Those little things in the back are just variable resistors, you could find out the resistance value then buy another variable resistor just like it and solder it in yourself.

---

How do I find out the resistance value? DO I have to call vestax? I found a local store that carry many variable resistors or potentiometers but I have no idea which one to buy.

Thanks!