Hello,
I can not install the firmware. I filled out everything in the Firmup window.
When I press start it says: ERROR ACK is not found
Can anybody help me please??
Hello,
I can not install the firmware. I filled out everything in the Firmup window.
When I press start it says: ERROR ACK is not found
Can anybody help me please??
still the same problem. it says: ERROR ACK not found
Hope someone can help
Are you entering bootloader mode when you turn on the VCI (press FX 1 + FX3 button on left side)? Run firmup.exe and then turn the vci off and on.
Yes I did. Now its even worse!! When I switch on the controller just the orange an red leds are on. When I press the button: "Get Version" it says "There is no reply" :-(
That's odd. Try the suggestions in this thread:
http://forum.djtechtools.com/showthread.php?t=63634
thanks for the link.....but F...ck non of this works in my case. I can do what I want...... it always says:
When I press "get Version": there is no reply
When I press "Start": ERROR ACK is not found
and the VCI stays constantly in Bootloader Mode
Hallelujah!!!!!!!!!!!!! It works. Flashflooder saved my live! Thank u so much
Sorry for my bad english, because I french, but I try that you understand me.I just receive my VCI400, and Its a great product. The problem with all the problem everybody have, is that DJTECHTOOL Support, is only guy, who passionate for djing, but not have great computer service knowledge and its for this you not have all the requirement for upgrade the firmware. All the problem in this forum about ACK not found is about that.
First of all, when you go to upgrade your firmware, win win xp, vista or seven.
-YOU MUST go to the site of vestax, and download THE DRIVER, because on seven all the audio driver not recognize,.
1 -Turn on your VCI400.
2-Plug it to your usb slot, and wait the incomplete installation
3-Install the driver, follow, follow, and follow
4-Wait for the recognize vci400 Hardware.
5-and after turn off your hardware.
6-Press the 2 FX buttons, and turn on your VCI400, and release the buttons, about 4 seconds after turn on
7-Check your firmware version, and follow the instruction.
That's all
How did you fix it? in traktor the controller says not connected.