MF Twister Traktor Mapping questions
I have a few questions I can't get past in finalizing my MF Twister Traktor mixer mapping:
1) I am trying to work out a way that I can get the side buttons to cycle through assigning the FX Banks to decks. Since I am trying to get this to be a 4 deck mixer, my two ideal thoughts of how this would work are that each of the four buttons controls a deck and that pressing one either cycles through FX1 ON, FX2 ON, All FX ON, All FX Off; or that pressing one toggles all FX on and then off; or something similar etc. No matter how I seem to have it mapped in traktor, all it seems capable of doing is turning off an FX bank from a channel rather than being able to turn it back on again... my buttons are all set to CC hold. Perhaps that is part of the problem? on the other pages of the MF I am using them for deck sync I/O, Flux I/O, and Master volume up and down.
2) I have the encoders able to simulate a jog turn however since these encoders do seem to be programmed to have a limited turning distance (Ie almost like a knob) they can't do infinite distance jog turns and will run out of space. Is there a way to bypass this on just one row of knobs on one page?
3) Is there a way to default the encoder values to start at a certain level other than adding a detent? For instance gain should start at the top of the knob however doesn't really need a detent, and channel volume I believe in traktor starts at 100% whereas the MF knobs start at 0%