Originally Posted by
pacific808
I was hoping to have enough room to install a mounting dish(recessed metal plate commonly found on passive speakers) but there wasn't room so I settled with having the ports exposed as they are. I really would have liked to have had water/dustproof doors covering them.
Drilling the main hole for the ports was my first step. I didn't have the CDJs when I drilled them so it was kind of a gamble but I figured the audio cables I was using was thin enough to work with. I used a straight edge to make a center line and then a ruler and math to distribute the center point of the holes. After drilling the larger holes I placed the ports in and then drilled the smaller holes for the screws. In my haste I didn't check that the ports were perfectly leveled so some appear off angle a little. After drilling I used a large snap off blade to cut the foam on the inside of the case. I had to make sure there was enough room to get the nuts on the screws that would hold the ports in place.
I will try to get more pictures soon.