Effects Select on FX Unit 1 with Shift modifier and Fader/Knob

I have an interesting problem that I am hoping someone might be able to give me some insight to.

I have a standard edition VCI-400 and I am slowly creating a mapping to emulate the EGE mapping. I have set my Effect 2 Select for FX Unit 1 to VR2 (or Ch 13.CC.002) with my shift (i.e. modifier) selected. When I set the Interaction Mode to Direct and adjust the knob it jumps to no Effect and I am unable to select any other effect. I have set up the other two effects in effects bank 1 and all of the effect in effects bank 2 the same way and they all work fine. I have found a work around by setting this particular knob to relative instead of direct, but I should not have to do this. Any thoughts??

Peace...

Make sure that effect selector command is set as type of controller-fader/knob and interaction mode-direct.

Stewe.......Thanks for the reply, my setting were as you described but what I ended up doing was deleting the command and then putting it back in. Doing this fixed my problem.


Thanks again!

Stewe seems to be the man to go to with mapping problems. big ups man.

Quote:

---

Originally Posted by fitzyp

Stewe seems to be the man to go to with mapping problems. big ups man.

---

Thanks man! I'm getting my title seriously :)