OK.
Two new files hot off the presses:
Size (Hold Down) + Turn the Dry/Wet Knob = Army Of Me Whoosh
Rec (Hold Down) = Echo -- You can also turn the knob while pressing
Play (Hold Down) = Reverb -- You can also turn the knob while pressing
Undo (Toggles) = Echo Freeze
Whats new?
You can know choose to assign all of the effects to each channel by using the 1 & 2 buttons next to the gain knob.
Channels C & A:
Button 1 = All Units Assigned to Deck
Button 2 = All Units Off (Blinking Button)
Channels B & D:
Button 1 = All Units Off (Blinking Button)
Button 2 = All Units Assigned to Deck
I tested this and it seemed to work well. It's best to train yourself that the blinking button will turn off the effect. Hitting the regular button will also work but the opposite button will continue blinking. I can also turn off the blinking but I figures it would be a good reference in a dark booth. If it's too busy I will create a non blink version.
To Install:
Click import in the bottom of your preferences, find the file and enjoy the goodness. Install appropriate version to your copy of traktor. The only difference is the T2 has the new effects in the list and will load properly.
Issues:
Sometimes when importing to T2 effect assignments in the S4 firmware goes wacky. It will act like there are only 2 units assigned to work. What I found is you can go into your preferences, switch back to 2 effect units and then switch back again to 4 effect units. This solved my issue in seconds. It's a super easy way to fix the problem; otherwise a reboot of your system should solve the issue. This will only happen the first time so first timers fear not!
Also I'm up for ideas, it was tricky to get this to work. Most of the upper part of the S4 is very restricted in the way it works.
Bookmarks