VCI-100SE v3 mapping will not work at all!

[colly]

Hey Guys,

I have the DJTT VCI-100SE and have been using the v2.5 mapping or the last while. I'm interested to try the v3 mapping - so I downloaded it, imported it, but absolutely nothing works at all. When I move any of the sliders or knobs, I can see the MIDI light on Traktor Pro lighting up, but none of the corresponding functions works in Traktor at all.

I have used maps where some stuff did not work, but not everything. I must be doing something wrong, any suggestions?
Thanks

[sj03w4t]

did you connect the vci-100 to the computer?

[vageotter]

set ports in and out to vestax controller
if that doesnt work, go to djtechtools productsupport/ 3_3mapping.
you can read about all the bugs there

[colly]

did you connect the vci-100 to the computer?

It works perfectly with 2.5 - I have been mixing on it all week. This morning I just clicked import, selected v3, and all of a sudden nothing works. If I import v.25 again it all goes back to working fine. Doesn't make any sense really

[colly]

set ports in and out to vestax controller

Sorry how do I do this exactly? Is that in Audio Device > Audio Settings? If so it is set that way, as I said everything works perfectly with 2.5 its just the actual v3 mapping

[colly]

Hmm, actually, do you need the latest version of traktor pro for this? I've still only got 1.2.1, maybe that's it...

[sj03w4t]

Sorry how do I do this exactly? Is that in Audio Device > Audio Settings? If so it is set that way, as I said everything works perfectly with 2.5 its just the actual v3 mapping

no, he meant a feature new in 1.2.4 (or 1.2.3)
I'd recommend upgrading see if that works

ok just read this from the mappings page on DJTT:

REQUIREMENTS
You must have Traktor Pro Version 1.24 or later
This file works with all VCI-100’s but those with firmware version 1.3 work the best.

[lethal_pizzle]

upgrade your software