Akai lpd8

[andydrew]

Im thinking of getting an AKAI LPD8 http://www.akaipro.com/lpd8

What I want to be able to do is use the knobs as effects units 3&4, no problem there I assume. But as for the buttons I want 3 functions, toggled by the extra buttons on the left. One mode where they are hotcues 1-8 for deck A, second the same for deck B, and third to control the effects on units 3&4.

I was also thinking that the LEDs could be lit up when each effect is on for units 3&4 at all times.

Is it possible to get 3 functions out of 1 button? At the minute Im using traktor LE but will have upgraded to Pro by the time i have the controller so can't check. Is the software that the LPD8 uses flexible enough?

thanks

[BradCee]

modifiers, but as you can only assign 2 conditions to a mapped function, and you have 3 buttons you'll need to use states 0, 1 and 2.

Hot Cue A mode button
Mod 1 = 1
Mod 2 = 0

Hot Cue A buttons
map up with conditions m1=1 and m2=0

Hot Cue B mode button
Mod 1 = 0
Mod 2 = 1

Hot Cue B buttons
map with conditions m1=0 m2=1

Effects mode button
Mod 1 = 2
Mod 2 = 2

Effect controls
map with conditions m1=2 m2=2

hope this helps

[andydrew]

ah very clever thanks

[BradCee]

no worries, using that technique you can give a single button 64 different functions

[andydrew]

thats a lot of functions!!!!

[bumtsch]

You may have issues with mapping the leds though. From what I can tell, when I press a pad which should trigger its own led it's like the built-in led flash cancels it. Lighting other leds from a different pad is no problem though.

[andydrew]

is it possible in traktor to change whether something like turning on an LED happens when a button is released or pressed down?

[BradCee]

is it possible in traktor to change whether something like turning on an LED happens when a button is released or pressed down?

http://www.djtechtools.com/2010/05/3...ds-in-traktor/

[DJMutagen]

This is how I've been using mine! :-D I LOVE IT! I wish I had another 'elavation unit' for my franken controller (which has an lpd8 on it) so I can have it level with my laptop

[BradCee]

modifiers, but as you can only assign 2 conditions to a mapped function, and you have 3 buttons you'll need to use states 0, 1 and 2.

Hot Cue A mode button
Mod 1 = 1
Mod 2 = 0

Hot Cue A buttons
map up with conditions m1=1 and m2=0

Hot Cue B mode button
Mod 1 = 0
Mod 2 = 1

Hot Cue B buttons
map with conditions m1=0 m2=1

Effects mode button
Mod 1 = 2
Mod 2 = 2

Effect controls
map with conditions m1=2 m2=2

hope this helps

just remembered those 3 buttons aren't mappable.

you need to use the 'program' button to change the signals of the pads/knobs and map these in traktor. if you get the editor software from akai site you can check that each program ('preset' in the software) has different cc's/notes.