Originally Posted by
FLoer
hello,
for the last 3 days i was trying to setup my laptop to work with ableton and traktor+soundplant.
my setup:
vci100 FW1.4, audio2DJ, Laptop: Acer Aspire 5930G (+Mixer just for external audio routing)
Soundplant, Traktor, AbletonLive8
virtual Audiokabel, Asio4All
routing:
Traktor (virtCable)
------> master : virtCable1 (out)
------> monitor-cue: virtCable2 (out)
soundplant (virtCable)
------> virtCable3 (out)
Ableton (asio4All)
//(in)
<------ audio1 : virtCable1 / traktorMaster (in)
<------ audio2 : virtCable2 / traktotCue (in)
<------ audio3 : virtCable3 / soundplant (in)
//(out)
-------> audio1+audio2 : Audio2Dj Ch A
-------> audio3 : Audio2Dj Ch B
theoretical everything should work, imo.
but it does not.
i tried a lot of buffer-variation through asio4all, audio2 driver, or virtcable. even buffer of 2048 does NO change at all. it still cracks
some things i noticed.
when i only use the master channel (audio2DJ ChA) everything works fine. if i active ChannelB the cracking starts on both. so, if i turn off ChB in asio4All it works fine.
if I move the cable from the audio2 too much is easily looses connection to my laptop, even the cable doesnt leave the socket.
and i think it said, that it should work better on usb2.0, when i installed the driver. i looked after it, and my laptop only has 2.0 ports, so why did it come up?
i appreciate any help, suggestions, or info on how you may connected your software sound-outs, with virtual audio cable, or other software.
Bookmarks