Hi everyone..
I (finally) received my bcr 2000 and allready have a big problem!
I connected the controller to my laptop and installed the drivers..
Now I was getting started with mapping the bcr..
I'll tell you what I've done so you can see if I've missed something
Connected the bcr and turned it on, installed the drivers, ...
Started Traktor SP
Opened the MIDI SETUP and set all the bcr inputs and outputs to ACTIVE
Went to MIDI Mapping and pressed add; mixer; effect unit 1 ON
Interaction mode: toggle; type of controller: button; assignment: focus
didn't do anything else to those settings.
So I press LEARN and press on a button of the bcr
BUT I don't get anything with assigned.. so traktor doesn't get the signal from the bcr..
And the midi indificator doesn't light up or anything..
So I reconnect and so on but nothing..
I start up Traktor 3 and repeat everything and that DOES work
Is there anything I have forgotten? If so, why does it works with T3 and not with TSP?
Hope someone can help me...
Greetz.. Tical
Bookmarks