s4 EQ knobs.

[karma]

Hey guys i'm new to the forums im just wondering about possible putting some of the dj tech tools fluro coloured knobs to brighten up the controller.

I was wondering what steps i would need to undertake this task.

[fullenglishpint]

Ibtf!

Edit: Actually I don't think it is that easy... there are a couple of threads on it and I seem to remember someone had to very carefully widen the hole on the bottom of the knob with a screwdriver to make it fit the post properly.

[padi_04]

Ibtf!

Edit: Actually I don't think it is that easy... there are a couple of threads on it and I seem to remember someone had to very carefully widen the hole on the bottom of the knob with a screwdriver to make it fit the post properly.

I think the problem was depth actually, knobs wouldn't go all the way down.

[fullenglishpint]

ah yes, same thing happens with my X1 (what a surprise )

They did manage it though didn't they?

[padi_04]

ah yes, same thing happens with my X1 (what a surprise )

They did manage it though didn't they?

Yeah, they heated a screwdriver or something and carefully melted the pot on the inside till it had gone properly in. Jason and Yul are the men to ask.

[VanGogo]

That was me, and it was for the faders only that I had to do a little McGuyvering with a screw driver.

The knobs go on no problem!

They do sit slightly higher than the stock knobs, but it's not that much higher. You could always drill them out a little to lower them.

Heres the original thread. http://www.djtechtools.com/forum/showthread.php?t=24213&highlight=djtt+knobs