VCI-100SE jog wheel side

[speyburn]

Hi,

I recently bought a SE edition of the VCI-100, and i have been setting and configuring it for the past couple days.

Since im still using my CDJ:s also i'd like the vci-100 to act like them as much as possible.

So my question is: how can i modify the .tsi so that the pitch bend will be the same on the side of the jogwheel as it is on the top? (i've used to pitch bend on the side of the jogwheel by habit )

Thanks in advance!

[Glen]

im not sure if you can, because i know the top is where the touch sensitivity is, and that is what makes it able to function. I don't think you can. Maybe, but i would bet not, sorry bud

[fullenglishpint]

Can't you just turn scratch mode off?

[speyburn]

Sure i can, but it wont remove the problem :/

When i bend on the top of the platter it +/- the BPM very little, but when i do it from the side of the platter it bends much more if you get what i mean?

[photojojo]

Doesn't the DJTT mapping have that in it?

[fullenglishpint]

never noticed that. You'll want to find the pitch bend commands in the mapping and change the sensitivity.