Replacing UC 33 Knobs

[Demetrius_FR]

Hi DJTT !

I want to replace the knobs of an UC 33. Does anyone know what kind of knobs could fit ?

The best will be some glowy knobs (as those who are sold on DJTT)

Thank you

[Demetrius_FR]

Anyone got an answer ?

[Patch]

Like this:



http://www.djtechtools.com/forum/sho...&postcount=203

These are the knobs I used (they're much cheaper now...):

http://cgi.ebay.co.uk/MIXER-CIRCULAR...#ht_500wt_1156

[Demetrius_FR]

http://www.banzaimusic.com/Knob-Soft...-top-11mm.html

I found that, but didn't know which knob will fit.

[Patch]

The new knobs are fitted for 6mm serated shaft type pots. The UC-33e and the UC-16 have both got D type shafts on the pots. It meant drilling out the new knobs with a 6mm drill (easily done by holding the knob in your hand (tightly) and then drilling out the serated part with an electric drill) and then rolling up some paper and putting in the pot. The paper gives it a nice tight (interference) fit when you push it onto the shaft.

Be careful with the drill!!!!

[Demetrius_FR]

Thank you man , I will check this.