Then something is wrong with your mapping.
Make sure you don't have any Modifier conditions set. Make sure the buttons are mapped properly.
Then something is wrong with your mapping.
Make sure you don't have any Modifier conditions set. Make sure the buttons are mapped properly.
the only other modifier i made is Modifier 5 as a Hold Button ...but it shouldnt interfeer,
would i be able to send u my .Tsi File ?
or up load it for u to see
fx parameter 3 M1=0 Fx 1 Bank
fx parameter 2 M1=0 Fx 1 Bank
fx parameter 1 M1=0 Fx 1 Bank
fx parameter 3 M1=1 Fx 2 Bank
fx parameter 2 M1=1 Fx 2 Bank
fx parameter 1 M1=1 Fx 2 Bank
fx parameter 3 M1=2 Fx 3 Bank
fx parameter 2 M1=2 Fx 3 Bank
fx parameter 1 M1=2 Fx 3 Bank
fx parameter 3 M1=3 Fx 4 Bank
fx parameter 2 M1=3 Fx 4 Bank
fx parameter 1 M1=3 Fx 4 Bank
that is how the knobs are mapped
and the modifiers are mapped
Button 1 -> Modifier 1 -> Direct -> 0
Button 2 -> Modifier 1 -> Direct -> 1
Button 3 -> Modifier 1 -> Direct -> 2
Button 4 -> Modifier 1 -> Direct -> 3
should the modifiers be dubbled ?
Button 1 -> Modifier 1 -> Direct -> 0
Button 1 -> Modifier 1 -> Direct -> 1
?
You can. To do this you'd need each button to turn off the other modifiers.
I'm still not sure why this isn't working. Can you upload a screenshot of the controller manager to the thread? I can't see photobucket or file sharing accounts, but I can if you just add it directly to the thread.
You still have your modifiers wrong.
They all need to be under Modifier #1. There should be 4 entries for Modifier 1, each with a different Direct Value of 0, 1, 2, and 3. They should each be mapped to a different corresponding button.
EXCELENT >...>Thank you soo Much ...its Perfect now ...
i owe u a beer sir
Last edited by Decible; 05-02-2011 at 05:40 PM.
|
Bookmarks