LED out not working

[moey2k2001]

Hi

I've been trying to map an LED out to the loop command I set but I can't figure out how to do that.


I've mapped the MF3D

Ch03 Note E2 - Type of controller: Button - Intercation Mode: Direct - Assignment: Deck A - Set to Value 1

How do I make an LED out active when the "loop" command is set on? I know that I the value for the On command should be 76 due to the color green.

Any input appreciated.

MOE

[Stewe]

Add out > 'is in Active Loop' Using this command?

[moey2k2001]

Out > Loop Active On ? Or not?
Min 77 for light green and 76 for bright when on. Min 0, Max 0. ???

[Stewe]

Nope. It's 'is in Active Loop' under Deck common menu > list bottom.

Should be 66 for green if 3D now has same LED velocity as Spectra.

[moey2k2001]

Nope. It's 'is in Active Loop' under Deck common menu > list bottom.

Should be 66 for green if 3D now has same LED velocity as Spectra.

No on the 3D its different according to the documentation. Oh now I found it. I'm not working it for some reason.Screen Shot 2013-06-25 at 3.19.08 AM.jpg

[Stewe]

You have correct modifier condition there?

[moey2k2001]

Yes. I cant imagine it being wrong. I even tried a different button that has no button and mapped all functions there but also didn't work.

[Stewe]

I can't say for sure about 3D though... Try setting range to 1-1 and combine blend.

Not all controllers are treating traktor output the same.

[moey2k2001]

Could it be that I messed up? As you know the MF3D has 4 Banks which I enabled them including the RemixDeckFirmware.
I used the "Modifier 1" basically on three pages so far. Technically its the same shift button, or not?

Bank1 & Bank 4 should control Deck A & B. Simple mapping such as Play, Cue, Sync, Loops & Hot Cues. Bank 2 should be EQ. Bank 3 FXs.

So far I've mapped all except Bank 3. I havent figured out the right settings for LEDs on Loops & Hot Cues. Everything else works like a charm.

[Stewe]

Could it be that I messed up? As you know the MF3D has 4 Banks which I enabled them including the RemixDeckFirmware.
I used the "Modifier 1" basically on three pages so far. Technically its the same shift button, or not?

It is a same modifier but it's not the same shift because each bank is sending unique midi note. Meaning, if you press that shift in any of banks the same modifier will be activated unless you add multiple mapping devices and assign each bank for individual modifier.