-
Tech Mentor
S4 autoloop question
HI everyone I wanted to ask this question.
Sometime when i want to do a big biuld up i usually auto loop the deck starting with 8 bar that going into 4, 2, 1, and lower and lower till the lowest amount.
though my s4 seems to be skipping from 8 it goes straight to 2, and than from 2 1/2, from 1/8, it does not follow the order when i do it with my llittle fat knob on the right corner above loops.
ANYONE KNOWS how to set up that way it will follow the sequence
-
DJTT Infectious Moderator
Check that you don't have a duplicate mapping in the controller manager. I suspect you actually have two duplicates that you need to delete.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks