Clear Arcade Buttons

[DJ_Pabloco]

i saw the new MF buttons and went on a search for even better ones.

http://www.canadianjoysticks.com/pro...ushbutton.html

would those fit in the MF?

[mist-man]

I just did some searching...

I found nothing that would indicate how long they are. Although if you could find the name of the manufacturer and check their website, I'm sure you would find a detailed schematic.

You could even get a small batch of them and give it a shot. 24mm refers to the diameter of the mounting hole, so these fit the hole... just may not be the same length to fit in the midifighter's terminals.

[mist-man]

actually, I think I just found it's schematic after all. and I'm pretty sure it's gonna be .4 mm shorter than the Sanwa OSBF-24 which is what the midi Fighter uses.

That should still be long enough to fit with out much of a problem, I'd bet.

[djproben]

buy one or two to test them out before getting all 16 ... make sure the snap is acceptable. There are some arcade buttons that suck.

[photojojo]

Sure you can make them work. It may involved manufacturing a new faceplate, or running leads to your buttons. I'm positive it can be done though.

[space monkey]

maybe you could get the faceplate mounting stems shortened by 4mm?

[djkrugger]

I've got these for my project and the quality is very good (seimitsu japan) i'm planning to light them up from the underside

[MrSteve81]

I know Sanwa have recently brought out clear 30mm buttons. Don't know if they are planning 24mm though.

[mist-man]

I really think these will fit just fine with out any modification, honestly.