Originally Posted by
jord1242
Not sure if this is the right place to be posting, first time poster here and hoping to find some help learning how to make a custom mapping for the apc40 in Traktor 2.5.
First things first, I try and map the cue level button (Ch01.CC.047) to the cue monitor level and it appears that even though it is a rotary knob, it basically turns it on or off. Was hoping it would send values (0-127 or whatever the max would be). Any reason why it is not? I have that set as:
IN - Monitor Volume Adjust
Type of Controller: Fader/Knob
Interaction Mode: Direct
Assignment: Global
No Soft Takeover or Invert
Then I am trying to map the Track Selection 1 button (Ch01.CC.023) to a modifier (so if this is selected, then I am in Hotcue Mode and then the buttons above will act as hot cue buttons 1-8. I have it set as:
IN - Modifier #1
Type of Controller: Button
Interaction Mode: Direct (tried Hold too)
Assignment: Global
Set to Value: 1
OUT - Send Monitor State
Modifier Conditions: M1 - Value - 1
Type of Controller: LED
Interaction mode: Output
Assignment: Global
Controller Range: 0-1
Midi Range: 0-127
No Invert or Blend
The light seems to light up when you click it, and if I click off of it (say Track Selection 2) it turns off. Regardless of the value I use in the OUT.
I know I am new and I am probably missing something easy, but if anyone could offer me some help I would greatly appreciate it! Even tuts or vids on learning how to map the apc40 to Traktor would be great (yes i did google it, didn't find a lot of help).
Thanks,
JJ
Bookmarks