Jog Wheel Fx

[sal.jaffer]

even if i put the d/w on the wheel it doesn't move

[zestoi]

even if i put the d/w on the wheel it doesn't move

sure - which probably confirms what i said about the wrong effects unit mode.

there are completely different things to map for wet/dry between single and group mode effects units. if you're not mapping the right type of control for the current effects unit mode then nothing will happen.

i.e: "in/fx group/dry wet group" verses "in/fx single/dry wet single" - they're completely different.

[sal.jaffer]

so should i concentrate on just 1 fx or ?????

[zestoi]

so should i concentrate on just 1 fx or ?????

no. just make sure you are using the effects unit in "group" mode and make sure you are adding the "in > fx group" mappings and not the "single" ones.

if you are using traktor pro 1 and not 2 then i think they're called "chained" and something else that i forget... "chained" is the same as "group" i think

[sal.jaffer]

im using traktor scratch pro 2 so can u plzzzzzz help a brotha out step by step if possible plzzzzzzzzzzzzzzzzzzzzzzz

[zestoi]

i have been. it just seems like u either aren't using the effects unit in group mode (check your settings) or have mapped stuff thats meant to single mode - if so delete them and remap using the group ones.

if you're sure that thats done then check the settings for each of the mappings u have from the jog wheel to the effects levels.

you'll need:

* type of controller: encoder (probably set to fader/knob by default, this could be your issue)
* assignment: fx unit 1 (or whichever fx unit u want to control)

then experiment with these settings:

* interaction mode
* enc. mode
* rotary sensitivity
* rotary acceleration

as they'll depend on your jog wheel and how u want to apply the changes