-
Tech Mentor
BCR Overlays
So I ordered some of the plastic overlays for my bcr ( http://www.lexplastics.co.uk/ ) and they are a bit warped. They do not fit perfectly and sort of "pop-up". I have had them on a flat surface under about 30lbs of weight for a couple days now to no avail.
Anybody else had this issue? Anybody have a success story?
-
Tech Wizard
You can always glue them with one-secondglue.
-
-
Yeah, I got them too and was a bit pissed off at the poor quality at firts.
Trick is to roll the overlays in the opposite direction with quite a small curve but without getting folds offcourse.
I got them pretty straight, but still use a few bits of tape to keep them in place.
They do work this way, and sure beats masking tape if you switch regularly.
Hope this helps
-
Mr. Golden
Hey dont talk too much smack about overlays
ours rock! But they are OEM quality and not the plastic variety that most people usually make.
-
-
Mr. Golden
we should- that could be fun.
-
-
DJTT Dominator
@ Tekki
*lost* whats a bcr?
*runs for the door*
-
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks