Ok, hi all, new to DJing as well as the forums. I have a question about timecoded vinyl. As far as the data encoded on the vinyl themselves, does the system know where the needle is on the record by reading the data directly under the needle as well as the previous location or does it know where the needle is based solely on the data under the needle? I don;t that sounds very clear. Like, if you dropped the needle in the middle of the record and started spinning it, would it know its in the middle, or if the needle jumps? Or is it purely forward and backwards? The reason I ask is that I do a lot of Christian Marclasy-esque vinyl cut-ups (ex: http://soundcloud.com/zachcollins/se...tled-piece-for ) and was wondering if this would be possible with a DVS system.
Another question I have (assuming this would in fact work) is would it be possible to record the audio output of timecoded vinyl, cut it up in an editor, play it back and route that audio into a DVS system?
I know these aren't typical typical DJTT questions (not exactly DJing either) but any help would be greatly appreciated. Thanks all.
Also, sorry about how incoherent this is, I stayed up all night drinking and trying to fix a TT I found on the street and now I'm in the middle of a 10 hour shift at work. My brain is essentially fried.
Bookmarks