Controller / S4 stand?

[Jay Wilde]

One of the complaints I keep reading is that there is some pushback at clubs if you start moving their gear around.

Well, we have laptop stands... does anyone make a robust CONTROLLER stand?? Would pretty much solve the issue of moving things around if you could just elevate the S4 above existing gear....

Anyone make this already?

[Conall]

Iv seen a solution with rubber stopped attached to the bottom of the s4 so that it can sit on each cdj and above the mixer. Apparently it works very well

[photojojo]

You could get a deck saver for a DJM and set the S4 on it.

[skygear]

You could get a deck saver for a DJM and set the S4 on it.

true! there pretty inexpensive on ebay

[-Pepe-]

yea i know this problems,
Space Tek & Zomo doing stands like this, not especially for controllers, but for CDJs, FX maschines,..., which could fit for controllers too
check this links:

http://www.recordcase.de/lshop,showd...105369,,,0.htm

http://www.recordcase.de/lshop,showd...101777,,,0.htm

http://www.recordcase.de/lshop,showd...101767,,,0.htm

[Jay Wilde]

anyone using the Odyssey laptop stand? hows the stability for the laptop? tried putting the S4 on it? frankly id rather have my S4 up above the club mixer/decks and laptop off to the side somewhere...

[Jay Wilde]

surely people have come up with something better than the stanton uberstand and less expensive than the crane (Which isnt wide enough for the s4 anyway)....

[*Otter*]

I just got a Crane Standard Stand for this exact purpose. Its cheaper than the Uberstand ($80.00usd) and more stable IMO.

[CryderSteez]

You could get a deck saver for a DJM and set the S4 on it.

I got a pair of 1200 decksavers to set my S4 and laptop on for club gigs. It works great, when you're done with your set, just take everything off and it's ready to use for whoever's on after you.

[Jay Wilde]

I just got a Crane Standard Stand for this exact purpose. Its cheaper than the Uberstand ($80.00usd) and more stable IMO.

can you show a pic of the S4 on the stand? it doesnt get shakey when youre pressing/using knobs and buttons toward the edges of it?

curious to see how well the s4 fits on the crane