Results 1 to 1 of 1
  1. #1
    Tech Wizard
    Join Date
    Mar 2012
    Posts
    22

    Default VCI-100 stuck in boot mode

    Hi. I just flashed my vci-100 to the 1.4 firmware using the djtechtools kit and a serial-serial cable. The flash went ok; I reassembled everything correctly, properly affixed the screws and paper backing, and reattached the harness. But now the VCI does not turn on; only the power button lights up, and it's not detected over usb. I've tried re-flashing three times. Any suggestions?

    Thanks in advance.
    Last edited by drusha; 04-15-2012 at 03:07 PM.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •