-
VCI-100 stuck in boot mode
Hi. I just flashed my vci-100 to the 1.4 firmware using the djtechtools kit and a serial-serial cable. The flash went ok; I reassembled everything correctly, properly affixed the screws and paper backing, and reattached the harness. But now the VCI does not turn on; only the power button lights up, and it's not detected over usb. I've tried re-flashing three times. Any suggestions?
Thanks in advance.
Last edited by drusha; 04-15-2012 at 03:07 PM.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks