How to put on a VCI-100 Overlay

[BentoSan]

http://www.youtube.com/watch?v=XB8iIktlnbg

Things you will need:
1x Phillips head screw-driver
1x VCI-100 Overlay
1x Stanley knife or razor blade.

Optionally you may wish to buy black knobs and faders to go with the overlay if you dont already have a black VCI-100, these are availible in the web store.

[jrssandoval]

hey guys this video is awesome and i apprecieate you guys helping the Digital Djs, i would like to know WHEN WILL THE OVERLAYS BE IN STOCK AGAIN GUYS???? I NEED ONE BAD AND WOULD ORDER IT TODAY AS WELL ASS THE FRIMWARE KIT....ALMOST THE END OF JANUARY AND NO OVERLAY....
THANKS ALOT ( I WISH I HAD ENOUGH $$$ FOR AN SE BUT I DONT)

[Davelazy]

I've got the new mapping overlay, can I stick it on top of my old one? or do you recommend I remove this and then apply the new one?

[Roninja]

I too would like to know if I should remove the old overlay and how would you recommend doing this?

Thanks

[basspenetrator]

never done it, but read several posts that there's no problem putting one overlay over the other.. i guess there some kind of different feeling on the small black knobs, but it will work.
there's a thread discussing how to remove the old overlay. they say that brute force and heating up the old one a bit should do the trick..

[Davelazy]

Hi,

Just updating you, I started to take the old overlay off, but it was really tough i sliced off a strip from one side then decided to just go ahead and stick the new overlay on top of the old one.

Fits & looks fine by doing this, and saves you having to tear off the old one.

Now I've just got to get used to this new mapping before my next gig

[andreanegri]

I put the V3 overlay on my old v2 and I was able to do that without any problem.
I followed the above video step-by-step