Hi there,
I use a VCM-600 on a HP dv6-1523 with Traktor Pro.
I made a big mapping when i was on Windows XP on an old PC and all was fine.
I installed Traktor Pro on this HP with Vista. All was fine except my latency was too high, and it was only to try it, i am not a big fan of Vista.
So i made a dual boot, with Windows 7 32 bits, especially for Traktor Pro.
All is ok, all is working fine except the leds : in the first minutes of my set, all is ok but more time is going, more the latency of the led is big. For example, the led of PLAY A, if i press PLAY the led switch on after 30 secondes, and so on... If i make a set of 1 hour, the delay is about 2 minutes ! This is only an output problem, the track plays in the first ms.
I know VCM-600 doesn't support 64 bits, but i am on Windows 7 32 bits.
Anyone experience this, with VCM-600 or any Vestax's hardware, like your famous VCI-100 ?
And is there any drivers available somewhere for theses units ?
Vestax site or support doesn't help, they never answer.
Thanks for your help.
E.
Bookmarks