-
Spurious midi data
Hey
I've got a slight problem with my diy controller in that all
my knob/pots are sending out spurious midi data pretty much constantly. They are fine at 0 or 127 but not in between. This Is obviously really annoying as they can't be used effectively. Is there any way to filter the signals or alter my pots at all?
-
Dr. Bento
what DIY midi controller board are you using ?
-
Tech Guru
Are you using 10k OHM linear pots??
-
umc 32 with 10k linear pots cheers guys
-
Tech Guru
I checked the Hale forum here, http://forums.halemicro.com/index.php?topic=61.0 , and there are a few things he recommends. If they are 10k pots, and they're pulled to ground, and they aren't dirty, it seems like the best fix is to use the beta v2.1.5 firmware. You can get the firmware/bootloader/manual/configuration utility, here http://forums.halemicro.com/index.php?topic=73.0
-
tried cleaning them all...no luck. its odd as some knobs are perfectly fine, others all over the shop. what should i try cleaning them with?
-
Tech Guru
I use Deoxit D5. I've used it on everything from my old analog mixers to my midi controllers.
It cost around $15 a can, and one can will last a long time.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks