Map effect on button to blink?

[Kensic]

is that possible?

i have a vci 400, i have mapped alot pre-set effects on the pad buttons. and when i press on 1 of them (for example flange effect would turn on).

so my set up now is that when the LED is ON from any of the buttons mean there is a preset effect mapped.
my only indication that im using that effect is when the LED is OFF

is there away to make it BLINK instead of OFF?

help please,

i might think this is impossible. being trying different stuff for hours

[Stewe]

I assume you've mapped presets to 8 button pad? Modifier can help you with idea..

M1=1 ; M1=2 ; M1=3 ; M1=4
M1=5 ; M1=6 ; M1=7 ; M1=0

All values should be set to 'HOLD'. Now map 'Beat Phase' to all buttons and dedicate modifier conditions of each button.

[Kensic]

yes i have mapped 8 presets into 8 button pads.


i have tried for with the "Beat Phase" numerous of time, none of them work.

this is how i have it....maybe im during something wrong.

add in - button 1 - toggle - effect unit 2 - *learn one of the button pads*

add out - button 1 - *learn the SAME button pad* - check invert - **** when the effect is off the LED is lit, and OFF when effect is on****

add out - beat phase - *learn the same button* - **** here i messed with the controller range with different min/max values****

nothing works.

this beeat phase method works for the PLAY/PAUSE button.....i dont know why it doesnt work for the effect on.
add out - phase beat -

[Kensic]

yes i have mapped 8 presets into 8 button pads.


i have tried for with the "Beat Phase" numerous of time, none of them work.

this is how i have it....maybe im during something wrong.

add in - button 1 - toggle - effect unit 2 - *learn one of the button pads*

add out - button 1 - *learn the SAME button pad* - check invert - **** when the effect is off the LED is lit, and OFF when effect is on****

add out - beat phase - *learn the same button* - **** here i messed with the controller range with different min/max values****

nothing works.

this beeat phase method works for the PLAY/PAUSE button.....i dont know why it doesnt work for the effect on.
add out - phase beat -

[Stewe]

Perhaps the effect off LED prevents the beat monitor to lite up? Try deleting effect output and see if that help.

[Kensic]

Perhaps the effect off LED prevents the beat monitor to lite up? Try deleting effect output and see if that help.

yup tried that too...didn't work also. i searched all over the internet....i don't believe anyone has done with effect on button

[Stewe]

That is totally mappable, make sure you don't have any other conflicting LED output commands mapped for same pad. Start new mapping and map only this few commands to test.

[Kensic]

yup, this is on an all new fresh mapping page...to avoid conflicting.

i would like to think this is mappable

[Stewe]

Did you use modifier to engage blink?

[Kensic]

ofcourse, what ever the modifier i use on the button 1....i used it on beat phase