DIY Arcade mod Advice?

[Inov8DJ]

Hi all,

I've recently ordered the arcade kit, just waiting for it to arrive...

I plan to use the overlay to mark the holes, so after advice on the best way to make the holes..

Ive read people have done it using a file or using a drill press?

I havn't got a professional drill press, but If I chose this I was think of getting one of them budget drill presses that you attach a drill too..

Whats your thoughts?

Thanks in advance

[Fiffi]

My suggestion is to buy a decent round file and try it out. If you don't like it, then by all means try other (more expensive) methods. Cheers!

[Fiffi]

Keep in mind that the holes you make for the buttons should be no more than Ø 24 mm. The holes in the current overlay are Ø 26 mm.

[Chilly]

...and that's where i fucked up. crap.

[BentoSan]

I used a budget drill press