Traktor browser mapping for Vestax vci-400

[mankiewd]

Hello everybody,

I've downloaded the Traktor mapping for my Vestax vci-400 from the Vestax site, and for me, these mappings are ok except for the browser section. Apparently, the only thing I can do with the browser knob, is go up and down the list (turning) and change between mixer mode to browser mode (pushing).

I had a Numark stealth control where the browsing was very simple (perfect for me)*but efficient and I would like to remap Traktor to be approximately the same for the Vestax.

I was thinking about:

left shift + push browser knob to toggle between tree and list
dial the browser knob to go up/down the tree and the same when in list
when in tree, push the browser knob to expand/collapse

Now here's my question: is this possible and if yes, how?
I must admid, I'm an absolute noob with computers.

Anyhow, many thanks and all the best for 2014

[mankiewd]

After some experimenting, I succeeded in going up and down the tree and extend/collapsing it. Also I'm able to go up and down the list, but I just can't find out how to toggle between the tree and the list. Has someone have a tip how to do this?
Thanks for your attention.