Hi there!
My name is Tom, I'm from Germany and DJing for more than 10 years now. Recently I bought a Xone K2 to map with Traktor Pro 2. I disabled the Latching Layers to get multiple colors in Traktor on one layer.
Because I'm relative new to MIDI-Mapping I can't figure out, why the following happens. I want to do this procedure to switch layers:
Xone K2s left down button toggles Layer 2 (M1=1) with LED-Feedback on that button, so I mapped:
Switch on:
Modifier #1 / Ch15.Note.C0 / M1=0 / Button direct / Set value 1
Modifier #1 / Ch15.NoteC0 / M1 =1 / LED output / Controller 0-7 / Midi 0-127
Switch off:
Modifier #1 / Ch15.Note.C0 / M1=1 / Button direct / Set value 0
Modifier #1 / Ch15.NoteC0 / M1 =0 / LED output / Controller 0-7 / Midi 0-127 / Invert
Ok - so far this works.
Xone K2s right down button works as shift for Layer 3 (M1=2) with LED-Feedback on that button when held:
Modifier #1 / Ch15.Note.D#0 / Button hold / Set value 2
Modifier #1 / Ch15.Note.D#2 / LED output / Controller 0-7 / Midi 0-127 / Blend
This also works.
Let's talk about the things that drive me nuts:
- When I'm holding shift for Layer 3, Mod and LED toggles like it should be.
- When I'm pressing hold for Layer 2, Mod and LED switches on
BUT
also the SHIFT-LED switches on 'til I press Layer 2 again. I really can't figure out, how to map that only Layer 2 LED switches on. It's always combined with Layer 3 LED.
Please help me!
Thank you very much!
Tom
Bookmarks