Behringer DDM4000 Assembly

[SlickVikram]

Hello all, just took the cover off my Behringer DDM4000 and I'm having difficulty getting it back on properly. The outer panel goes back on just fine but I can't seem to get the circuit board underneath to a high enough level, it just sags back down and I can't figure out what it was that was holding it up to within a few centimeters of the outer panel. Has anyone ever had the same problem?
Any input would be appreciated.
Thank you

[Sambo]

Not opened one myself but perhaps the front panel was screwed on to the motherboard, therefore keeping it up?

[031999]

look at this picture http://www.behringer.com/assets/DDM4...TopPers_XL.png

there is quite a few screws in the faceplate, some of those got to be for holding up the knobs and stuff.

[SlickVikram]

That's what I was thinking but I'm having a hard time trying to hold the circuit board at a high enough level to the main one so as to get a screw in. To place a screw in to the top board, it has to be placed flat on to the mixer, leaving the circuit board sagging down and well out of reach.