Problem with mapping two separate functions to one knob in traktor

[mmourner]

Hi guys,

I'm writing, because I've encountered a problem with my traktor map.
I'm using xone k2 and I want to map high adjust and filter adjust to one knob, but the function will depend on whether one button is on or off. I tried doing that with modifiers, but it does not work. The knob is either disabled or the movement controlls the two adjusts at a time.

Ane tips?

[Stewe]

Can you please post a screen shot of setting just this two commands and the modifier so we can have a clear idea if this could possibly be an incorrect mapping or not.

[Yul]

Hello and welcome to the forums.

your button that is a modifier, we'll call it modif Z
Create:
modif Z /direct 1 when mod Z=0
modif Z/ direct 0 when mod Z=1
learn the led out for those
You've just created a toggling modifier switching between two states.


assuming your modif Z=0 state is your high adjust, create the command with Modif Z=0 and create the command for filter adjust with modif Z=1

Done that's basic mapping 101. There's no reason that shouldn't work (assuming the hardware type of buttons on the k2 doesn't interfere).

Let us know how it goes.

May I suggest reading that thread where you'll find good tips on mapping:
http://forum.djtechtools.com/showthread.php?t=23910

[mmourner]

Thank you Yul!

This works perfectly! I've just added an additional midifier condition for the trigger button and that was my mistake!

I managed to do LED mappings for those with no problem.

And thank you for kind welcome This forum is full of priceless knowledge