-
Would like some advice on best approach with modifiers.
Hello,
I am working on a custom mapping for my Mikro to Traktor. In the top left there are three soft buttons and a knob. The knob by default is mapped to the loop size of the active deck and clicking activates/deactivates the loop. What I would like the buttons to do is change the function of the rotary knob to change the Gain, Filter and Pan of the active deck. I think I have a handle on how to use modifiers to achieve this.
M1 = 0 Default State: Loop Recorder
M1 = 1 Gain
M1 = 2 Filter
M1 = 3 Pan
However I get lost when I try to figure out how to use modifiers to make it so if any of the three buttons are pressed it turns off any other button that was active (or not). I've tried this a few ways and end up with some erratic behavior so I figured I would ask the pros.
thanks
kris
-
DJTT Mapping Ninja Moderator
Controller range value should match the modifier IN state: 0-0, 1-1, 2-2, 3-3
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks