help with A10 and denon mc6000 set up

[nicholas mathias]

Hi all
wondering if any kind soul on this forum can help me with a lil problem i got..!!

both my denon and a10 are connected to usb ports
turntables are connected to a10 which are then routed to my denon
in traktor my mixing mode is set to internal and Monitor signal to the A10 Main out
the settings on my denon on the back is set to pc mix

i've now managed to get the monitoring from the A10 but i have encountered a few more problems.
1) i am unable to use my channel 1/4 for my denon as my midi decks C and D
2) channel 4 is now my master output for sound
3) i am using the master out(unbalanced) on the back of my denon to play through to my speakers which gives a very fuzzy sound.


any suggestions would be much appreciated..!!

[makar1]

You don't need to connect any audio cables to the Denon if you're using Internal Mixing mode. Connect speakers and turntables directly to the A10.

[SlayForMoney]

Also, make sure you have the latest firmware for the MC6000, there were like 6-7 of them issued. The latest one even has the option to use MC6000 for DVS without the A10 #hint #hint

[nicholas mathias]

Hi makar1 and slayformoney,
Thanks for the replies..
@makar1 i've now done that and when i plug my audio cables to the master out on the a10 and play them on the speakers it includes the cue sounds coming out as well.. My monitor routing is master Output L n R and my master routing is deck a L and deck B L.. Should it be something else?

@slayformoney thanks for the info.. I'll try to find the new patch!!

[makar1]

Did you connect your speakers to Output A on the A10?