Machine's remix deck mapping messes with traktor

[DjAzDeck]

Hi all. I am new in forum and I was informed that you may help me with my problem. Let me explain you my problem with few words.
So I use traktor with vms4 midi controller in my mac book pro. I bought machine to control remix decks. So I plug machine in, I press shift and midi to turn the machine into midi mode.after that I went on control manager in traktor and added machine mk2 with the tsi named control remix decks. So far so good. I press pads to trigger remix slots and etc the play from deck a is getting hit. Another example I use the 3 and 5 know under the screens in machine and then the master volume and the mid knob from deck d in equalizer starts moving...
As you can understand I think the machine mapping is messing up with vms4 mapping or what I can't fix it...
Pliz help me.
Thank you in advance

[Stewe]

Hi DjAzDeck,

I'm guessing that your controller mappings are set to 'All Ports' in the MIDI In-port Out port. If so, go ahead and set each part of the mapping (device) to display corresponding controller at MIDI I/O.

[DjAzDeck]

Yea that was the problem! Thank you very much! U saved me! Thank you again!

[DjAzDeck]

Hi DjAzDeck,

I'm guessing that your controller mappings are set to 'All Ports' in the MIDI In-port Out port. If so, go ahead and set each part of the mapping (device) to display corresponding controller at MIDI I/O.

That was the problem indeed thank you so much for your help! Really u saved me!