Replacement/Universal Knobs/Faders for DDM4000

[SMOR3S]

So I picked up a DDM4000 for $70 at Guitar Center, I am happy with my purchase, but it was on clearance, so it has no knobs and such, so I am wondering what knobs would be compatible, cause it appears the Chroma Caps aren't :/

[SlvrDragon50]

Do you know why they aren't compatible?

If the knobs are reversed, then Denon/A&H knobs will work. If faders sit too low, then just stuff something in the crevice that makes it sit higher.

[SMOR3S]

Do you know why they aren't compatible?

If the knobs are reversed, then Denon/A&H knobs will work. If faders sit too low, then just stuff something in the crevice that makes it sit higher.

DJTT shop says they aren't, I don't want to take the chances until I know why exactly.

I was looking at these though:

http://www.amazon.com/s/ref=nb_sb_no...ntiometer+Knob

[SlvrDragon50]

DJTT shop says they aren't, I don't want to take the chances until I know why exactly.

I was looking at these though:

http://www.amazon.com/s/ref=nb_sb_no...ntiometer+Knob

I would get a pair of calipers and measure the knobs/identify direction before ordering from Amazon.

Alternative:
http://forum.djtechtools.com/showthread.php?t=80553

[Jester]

The 90 degree chroma caps should fit.

[SMOR3S]

I would get a pair of calipers and measure the knobs/identify direction before ordering from Amazon.

Alternative:
http://forum.djtechtools.com/showthread.php?t=80553

Okay awesome!

I have been searching for the knob/fader sizes, but haven't found anything. I'll have to call Behringer in the morning.

The 90 degree chroma caps should fit.

Okay ty.

Judging by this image, what knobs are these? Cause they are installed them on a DDM4000

http://oi41.tinypic.com/12228e8.jpg

I think those are stock faders too, but I am going to need 5 faders, so what Chromas, do you think would fit?


Thanks.

[SlvrDragon50]

If you take a picture of your knobs turned full left I can compare them to mine. I am pretty sure the 90* chroma caps are what will work, but not 100% sure.

As far as faders go, you need to measure the stem or get the info from Behringer.