-
Problem: Nested Modifier States in Traktor?
Hey Guys,
I am running into a little bit of an issue here.
Its better if I explain it as ... this part is basically a toggle button between Modifier and M1 > M0
Modifier Button A: Sets M1=1
Modifier Button A: Sets M1=1 Back to M1=0
I am using Controller: Button, Mode: Direct and values 1, 0
Problem begins when I try to temporarily put another modifier state M1=2 while I am in M1=1 with Modifier Button B. Here I am using the Hold Mode because I want to get the state back to M1=1 when I let go of the button. But the state gets stuck at M1=2 and does not switch.
I am using this to switch between FX modes, single to group and back. So the knobs are temporarily switched to Effects selectors for the three slots then back to Dry/Wet for each effect. I plan on using 4 modifiers for the for fx slots and switching modes independently.
Is there a way around it?
-
DJTT Mapping Ninja Moderator
Set your second button to M1=2, then set value go back to 1 (with invert)
-
Nothing...
Does not work... unless I am doing it wrong.
Mapping here. https://drive.google.com/file/d/0B0V...ew?usp=sharing
-
-
This has the same effect as the one I made.
Hehe... I actually fixed it You forgot an invert send from Button B.
Thanks man!
-
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks