I use traktor 2.10 and cannot see a command for beat phase sync that tutorials here mention are mapped for flashing led! Is there another way or command used in traktor 2.10 to achieve this?
Thank you,
I use traktor 2.10 and cannot see a command for beat phase sync that tutorials here mention are mapped for flashing led! Is there another way or command used in traktor 2.10 to achieve this?
Thank you,
It's located under Add Out > Deck Common > Beat Phase
Controller Range Min: 0 / Max: 0.5
Blend: Off
Invert: Off
Thanks for that! Got it working. Now it's when I trigger a cell on a remix deck map! Now! How to stop it when I stop the cell!!! Any ideas?
Cheers!
You can use "Remix Cell State" modifier to set conditions for each cell state.
Empty.
Loaded.
Waiting (which have bugs)
Playing.
Ideally, the beat phase should be assign with "playing" state but the minimum LED output value should be the same velocity as your 'loaded" LED state (button color).
I see. I thought it may go down that route. II dontthink my maping skills quite up for it yet. I have so far used in my mapping addout>Global>Midi Controls>Buttons>Midi Button One> This was to light up all buttons/pads on PUSH. Pads represent the remix cells. They are all white. I am now thinking i would just like each pad to turn a colour when captured to switch colour and again a different colour when playing the cell. white light (empty cell) Orange(loaded cell)> Green (playing cell) . I have 32 cells to do this for. I am now going for that route rather than blinking for now. Any ideas for that route?
Cheers!
Last edited by PushA; 11-11-2015 at 04:44 PM.
|
Bookmarks