Traktor 2 Xone K2 mapping - Loop Size Selector Encoder

[Markkos89]

Hello guys! I'm trying to map the encoder for Loop Size Selector and I cant make it work... I've searched a lot on this forum (wich is great and read some nice people) and follow every suggestion but I can't make it work.

The configuration I have right now is the following:

Loop Size Selector
- Type of Controller: Encoder
- Interaction Mode: Relative
- Enc.-Mode: 3Fh/41h
- Rotary Sens.: 10%
- Rotary Acel.: 0%
Inverted

I read this configuration in this forum but didn't work also... either with 7Fh/01h..

I have Traktor Pro 2.6.3 and an Allen and Heath Xone K2

[Stewe]

Hi Markos and welcome to forums,

Normally it should be set to encoder as you already saw in the forum - try switch this in to Fader type. Rotary sensitivity should be around 100%

[Yul]

I don't have a clue as I don't have a K2 but I remember form my previous A&H controllers that some encoders are actually buttons (left and right messages). May be you should check that? I really don't know I may be not of much help here ^^

[Stewe]

I had a K2 for very short time, all encoders have a CC type of message unlike the Xone 1D controllers where the Note message was implemented.