So say I have the mixer levels at 8, I'm blending the track over to my right channel but it comes in to loud and I have bring that level down to 5 or so? Trying to figure out whats going on?
Thoughts?
So say I have the mixer levels at 8, I'm blending the track over to my right channel but it comes in to loud and I have bring that level down to 5 or so? Trying to figure out whats going on?
Thoughts?
What are the inputs into the respective channels?
And what way are your Gains/Trims?
Sent from my SM-G900F using Tapatalk
Denon DJ/MC6000KMK2/Launchpad S/LaunchcontrolXL/Traktor Pro 2/Bringin it since 96.
I'm assuming you're not panned. Do the meters indicate that the levels are correct? What is your speaker setup? You said you are plugging into a sub what are the connections from the sub to the speakers?
"Walking the fine line between Stupidity and Genious" My Soundcloud ---- My Mixcloud
MBP Retina 2015--TSP 2.10--2xDNSC5000--2xDNSC2900--2xDNSC2000--NI F1--Denon DN-X1700--HDJ2000--Stanton STR8-80--QSC K12's--Crown Amplifier--Urei Monitors
What software are you using? What's the position of the PCMIX/INTMIX on the back of the unit?
Denon X600 - 2x Denon SC-2000 - AKG K181DJ - NI Audio 2
"Walking the fine line between Stupidity and Genious" My Soundcloud ---- My Mixcloud
MBP Retina 2015--TSP 2.10--2xDNSC5000--2xDNSC2900--2xDNSC2000--NI F1--Denon DN-X1700--HDJ2000--Stanton STR8-80--QSC K12's--Crown Amplifier--Urei Monitors
I'm using Traktor Pro 2
Mixing mode = PC Mix
Output Source/USB Audio = Rec Out/Mic
Ok, we can do several things to check the software side of things (if it's that, it's probably either Traktor deck gains or Win/Mac volume control for separate channels).
But, before that we have to make sure the hardware is ok. Plug a CD player, mp3 player, anything with a RCA output into every channel on the MC6000, without laptop connected to it, any verify you have the same volume with gain knobs set the same.
Denon X600 - 2x Denon SC-2000 - AKG K181DJ - NI Audio 2
I'm using a PC and the settings on the MC6000 is set to MIDI, all levels & High, Mid, Lows are at 12oclock.
When I went threw all the RCA/Lines the volume is only 4bars with the sliders all the way up.
When you say volume control for the separate channels do I check that in the software?
|
Bookmarks