i tried to copy the map like 20 times and it doesnt change something.. :\
yeah for sure! there you go!
thanks!
ps. its not done yet!
Checking the mapping now. Your jog turn commands are mapped to two CC's right now (CC.034+CC.002)
Delete all duplicates and start with just one again. Then try to map "Jog Turn" by only nudging the jog on a side (not touching it on top) I believe this is CC.002
And use "Jog Touch On" command which you should assign by pushing the top of the jogwheel. (CC.034)
Isnt right?
Turning the jog : pitchbend stepless
Press the jog : jog touch (vinyl stop)
Press + turn : jog turn (scratch)
???
Fixed that for you
Turning the jog : jog turn (pitchbend)
Press the jog : jog touch (vinyl stop)
Press + turn : jog turn (scratch)
Tempo bend stepless is a button command that corresponds to Note ON and OFF messages and probably the reason why your Jog encoder mode always reverts to 7Fh which is velocity of 127 which is than the button Note ON sent by turning the jog wheel. Delete Tempo Bend, than replace it with Jog Turn and see how it goes from there.
I used stepless because when i was using tempo bend, the tempo bend arrow on the top corner of the waveform was still "on" on a side ?!
Really?
Whats the fonction to slow down and pitch up for beatmatching like on real vinyl/cdj on the side?
Jog turn 2x?
For the side cdj style and on the top when im pressing on the jog?
Last edited by Kurse; 08-09-2017 at 07:53 PM.
|
Bookmarks