Hey Guys,
I uploaded my first ever made mapping for Kontrol F1
This mapping is something I've made for my backup controller but it packs some serious power nonetheless.
Go to MIDIMAPS
Hey Guys,
I uploaded my first ever made mapping for Kontrol F1
This mapping is something I've made for my backup controller but it packs some serious power nonetheless.
Go to MIDIMAPS
haven't stress tested it yet. the workflow is quite different from what i am used to with my other f1 mappings. i`ll juggle it with my next home mix (techno as well)
It should be stable enough as the FX layer is a two year old mapping that always worked fine. Only the sequencer is newly added.
Finally getting around to testing it for real.
Needs fixing:
- SwappableFX(Unit4): condition (FXUnitMode=Group/Single) for button 1 to alternately toggle FXUnit=On/Off in SingleMode toggles FXUnit2 On/Off in SingleMode instead of FXUnit4.
F1.jpg
- Pressing the Knob in FX Mode clears (unloads) deck D (sequencer deck). It's not supposed to do that, right?
Edit:
btw, i can't find the toggle to switch from FX-controls to volume/filter controls (second mapping, modifier#1, ch12cc003). Did you remove it?
Edit2: Another small technicality. Should be Deck C instead of Deck A in the third of the marked lines.
F1b.jpg
Last edited by Sulherokhh; 10-21-2017 at 06:16 PM.
Feedback:
Haven't used the sequencer much, just a bit of testing. 16 pads are not enough for me using 4 slots.
I love your presets and their distribution among the 3 pages!
Thank you for the feedback and hunting down all the bugs! I've fixed them all and updated the mapping page with new version.
Fixed both issues. I usually add the Unload command to the mapping and map it to which ever button/knob CC I heed to find/locate/edit in the assignments table. Sometimes I forget to delete it before uploading and only for that reason the unload is used in particular because it's very easy to notice.- SwappableFX(Unit4): condition (FXUnitMode=Group/Single) for button 1 to alternately toggle FXUnit=On/Off in SingleMode toggles FXUnit2 On/Off in SingleMode instead of FXUnit4.
F1.jpg
- Pressing the Knob in FX Mode clears (unloads) deck D (sequencer deck). It's not supposed to do that, right?
If you look under the device#3 in v1.0 you will find it located at the bottom of the commands list. Simply forgot to delete it when I lastly edited the mapping
Yes. Only the modifier was removed but the commands are still in the mapping if I ever want to enable them again.Edit:
btw, i can't find the toggle to switch from FX-controls to volume/filter controls (second mapping, modifier#1, ch12cc003). Did you remove it?
Fixed - thanks!Edit2: Another small technicality. Should be Deck C instead of Deck A in the third of the marked lines.
F1b.jpg
Sequencer is what I use mostly. It's bad that Traktor has a bug with LED feedback on PC's but it should be usable when you memorize positions of all controls in the sequencer layer. On mac it works perfectly...
Glad that you like my presets they are super handy, especially when you work with just 16 pads.
I think i will put in the switch at least for the slot filters, maybe replacing the reverse grain fx. faders will stay with the FXUnit1/2.
One more small glitch: fader tape delay (layer 3, fader 4) switches the unit on only sporadically when pulled down to zero. Makes catching a soundbit a bit of a gamble.
And yeah, the LED's for the step sequencer have a small party here and there...
|
Bookmarks