Check your encoder settings in the MF Utility. Under "Encoder MIDI Type" select "CC" and then use Fader-Direct mapping for your Seek Position command. However this command alone won't act in a same way as "MOVE" encoder on X1, S4, etc.
To do so combine three different commands in to one macro knob mapping:
(Be sure to use 3Fh encoder settings for this one)
Add In -> Deck Common -> Move -> Size Selector (selects for how many beats track jumps in both directions)
Type: Button
Mode: Direct
Add In -> Deck Common -> Move -> Mode Selector (selects ether JUMP to seek trough a track or LOOP to move loop trough the track) (you can also define this via dedicated "Is In Active Loop" modifier)
Type: Button
Mode: Direct
Add In -> Deck Common -> Move -> Move
Type: Encoder
Mode: Relative (start at 30% sensitivity and adjust to your preference)
Bookmarks