Hey there,
First of all, I'm pretty new in this community so I don't know if it's ok to start a new thread. I previously searched for a the reason I'm posting here, but I didn't seem to find any about this specific problem or with a specific solution
My setup: Allen & Heath Xone 92 + NI Audio 10 + Traktor Scratch Pro 2.11.3 + Macbook Pro
The issue: I want to have my traktor's reverb in send mode but I cant get wet signal back into de mixer.
When I turn the auxiliary knob up (1 or 2, doesn't matter), my Audio 10 shows that the main input (ch 1&2 on the front panel) is receiving signal, but the output won't light up, so I'm guessing that my Audio 10 ain't sending the wet signal back into the Xone 92.
I'm pretty shure that I have everything set as it should be in my Traktor configuration:
Output Routing
Output FX Return:
L: 1 Output L
R: 2 Output R
Input Fx Send:
L: 1 Input L
R: 2 Input R
Xone 92 sends >> A10 Input Fx Send
A10 Output FX Return >> Xone 92 Returns
I checked the whole f***ing internet to find any solution but nothing. Native instruments (as always) have a really old ass post showing how to do it but in a Xone 4D and guess what, the send & return are different than in the Xone 92. There is no tutorial showing how to do this either on Youtube.
At the same time I checked in the Audio 10 Control Panel, and I really don't know if there's actually a way to configure the main output/input (ch 1 & 2). I couldn't find a way to do it on my macbook, and so didn't on the internet, of course.
I spent two hours of my life today standing in front of the mixer trying to figure it out without having any succes. I think I haven't been this frustrated in my life.
Bookmarks