Z2 issues, is it just me?

[barstarsounds]

so, i was playing a wedding last night, and i noticed that when i would start up another song, and switch over to it, it would sound almost as if the filter was on. i would move the knob a bit, and it would get it's bass back. this started happening about 4 hours into the event when things were really going. then with about 20 minutes left till closing, my left deck said it lost audio input left? (or something similar) but was still playing fine.

I was running it on a 2014 macbook pro running mavericks, and tethered to my Z1 which has the pitch control map loaded onto it. it was a controller only setup, so it wasn't receiving an audio signal from a set of decks.

I had this issue before with my turntables, and it was just a bad audio cable between the one, and the mixer.

has anyone else come across this issue?

as a side note, i'll cue up the next track, hit play, then i just bounce it back to the start position with the Z2's built in cue point buttons to the beat for the last 30 seconds or so.

[mattomstormy]

I know it is a bit late but I had the same issue and resolved it with turning the multicore processing off in the options. Hope that helps or it has already been resolved.

Cheers!!