Vestax Typhoon / Spin / Vci 300

Can someone help me here please?

I have the Vestax Typhoon and the crossfader on the internal mixer in Traktor has a not so sharp setting. Does anyone know a mapping configuration that will allow me to have the fader cut on/off for scratching like in Virtual DJ?
I assumed the sharpest setting in Traktor would be a on/off type fader.

I heard this was some type of problem people had with the VCI 300/Traktor combo too.

Quote:

---

Originally Posted by majestics

Can someone help me here please?

I have the Vestax Typhoon and the crossfader on the internal mixer in Traktor has a not so sharp setting. Does anyone know a mapping configuration that will allow me to have the fader cut on/off for scratching like in Virtual DJ?
I assumed the sharpest setting in Traktor would be a on/off type fader.

I heard this was some type of problem people had with the VCI 300/Traktor combo too.

---

Since I am pretty sure that the Typhoon, like the Spin, doesn't have a knob on the back to control the cross fader curve (like the VCI-100) you are going to need to adjust the mapping in order to get functionality similar to what you are describing.

The easiest way I found to do this is to add (or modify on an existing mapping) an "X-Fader" IN (under the Mixer section), set the Type of Controller to "Fader/Knob", then set its Interaction Mode to Relative and set the Rotary Sensitivity to 200% and the Rotary Acceleration to 100%. You can play around with the values a bit to get the cross fader as sharp as you like, but that should basically do the trick.