VCI-100 LED Question.

Hey guys,

Sorry, I've just bought a VCI so I'm probably gonna have a few questions over the next couple of days. The community here has always been very good to me so I'll hope you'll bare with me!

So, todays problem: Without going too much into it, I've mapped 'SET CUE' button below the jog wheel as a 'toggle' button. However, the LED will only turn green while the button is pressed.. ie the LED is acting like a 'hold' button when I want it to act like a 'toggle' button.

Is there anyway of changing this as I can't seem to find away and it's really gonna screw up the mapping I've been planning for this machine.

Thanks guys, any help as always is greatly appreciated.

Have you seen this?

http://www.djtechtools.com/2010/05/3...ds-in-traktor/