Smart Knob HELP!!

Ok heres the deal...I use a Vextax Typhoon and a Kontrol x1. When i do a sweep I'll use Iceverb, Peakfilter, and reverb in fx bank 1. I mapped one knob to control the dry/wet amnt, and then also the amnt of the 3 effects all together (wicked simple mapping).

What I want is when I start to turn that knob, it automatically snaps those 3 FX's into fx bank 1.

I would bet that this is posted somewhere on here already but after 3 hours of looking around and learning about smart knobs, super knobs, modifiers and advanced modifiers and still not finding out how to do that specifically, I was hoping one of you more experienced guys could answer the question for me in a few simple sentences.

Thanks Guys!

add in:
a modifier that is your knob/ set as a button on 'hold' for a value of 1
global> fX panel mode to group and assign accordingly, add the modifier condition =1
add all parameters linked to your chosen group of fx (all is within the drop down menu), add your modifier condition =1

What's your issue?

i guess i still don't fully understand. I just tried for like an hr to figure it out.

Basically i got a blank knob, i want that knob, when i turn it up to turn on and snap to Iceverb, Peakfilter, and reverb in fx bank 3 (changed my idea of where i wanted it) and correspondingly turn up the amount and dry/wet amount of Iceverb, Peakfilter, and reverb. then when i turn it back down, shut those 3 off.

figured it out, didnt realize if i set the knob as a direct button i could use the fx select to set a specific effect.

thanks!

No prob. By the way you don't even have to use a modifier in fact, my mistake, (I'm so used to have them implied).

Quote:

---

Originally Posted by Yul

No prob. By the way you don't even have to use a modifier in fact, my mistake, (I'm so used to have them implied).

---

I was wondering what the hell you were talking about, but you're generally smarter than me about midi mapping so I wasn't going to say anything until I could sit down and check out what you were saying. :)